Carbolite AX120 Manuel d'utilisateur

MF42 – 1.10 Installation, Operation & Maintenance Instructions 250°C Laboratory Fan Ovens – Apex Range models AX30, AX60 & AX120 T

Apex Series Ovens 10 MF42 1.10 6.0 FAULT ANALYSIS A. Oven Does Not Heat Up 1. The temperature controller is OFF  No power from the supply  C

Apex Series Ovens MF42 1.10 11 7.0 CIRCUIT DIAGRAMS & FUSES 7.1 Circuit Without Process Timer 7.2 Circuit With Process Timer

Carbolite, Parsons Lane, Hope, Hope Valley, S33 6RB, England. Telephone: +44 (0)1433 620011 Facsimile: +44 (0)1433 621198 E-mail: [email protected]

Apex Series Ovens 2 MF42 1.10 1.0 INTRODUCTION 1.1 The APEX range The Apex range of fan ovens comprises three models, of 30, 60 & 120 litr

Apex Series Ovens MF42 1.10 3 2.0 INSTALLATION 2.1 Unpacking & Handling Remove the shelves, runners and hangers from the packaging before

Apex Series Ovens 4 MF42 1.10 3.0 OPERATION 3.1 Operating Cycle The oven is fitted with an instrument switch. The switch cuts off power to th

Apex Series Ovens MF42 1.10 5 3.3 Process Timer (if fitted) To set a process time: Press the P key; t1 shows momentarily on the display and the

Apex Series Ovens 6 MF42 1.10 3.5 The Oven Door and Chamber It is recommended that the instrument switch is turned off if the oven door is to be

Apex Series Ovens MF42 1.10 7 4.0 MAINTENANCE 4.1 General Maintenance No routine maintenance is required other than the occasional replacement

Apex Series Ovens 8 MF42 1.10 4.5 Retrofit Kits Kits for process timer, overtemperature (hydraulic thermostat) and locking handle are available.

Apex Series Ovens MF42 1.10 9 5.5 Hydraulic Thermostat Replacement Disconnect the oven from the supply and remove the side cover (see 5.3). Als