MC18-GB – v1.04 Operating Instructions Temperature Controller Type 3216 P1 P5 Engli
Programming 10 MC18-GB – v1.04 Single Offset If a constant offset is required across the temperature range, set the required “High Point” (PNT.HI) an
Programming 11 MC18-GB – v1.04 Ramp Units Press scroll until the display shows RAMP.U <Ramp Units>: Use the Up Down to select the Ramp U
Programming 12 MC18-GB – v1.04 5.2 Running a Program If using the 3216P5 controller Press Scroll to display PROG <PROGRAM NUMBER> select the
Programming 13 MC18-GB – v1.04 Time Remaining Press scroll until the display shows T.REMN <TIME REMAINING>. This shows the dwell time remain
Program Example 14 MC18-GB – v1.04 5.4 Program Example The following sequence of entries creates and runs the program shown graphically below. 1.
Options 15 MC18-GB – v1.04 6 Options Because options can be ordered in a variety of combinations and for a variety of purposes, exact instructions
Options 16 MC18-GB – v1.04 6.3 Comms Address Typically the comms address is set to 1, but this can be changed. In the case of RS485 and multiple in
Navigation 17 MC18-GB – v1.04 7.1 3216P1 & 3216P5 WRK.OP TEXT WRK.OP rmp.8Prog Prog t.sp8ramp.U ramp.U dwel.8dwel.U dwel.UA1. #rmp.1 h.backA2.
Controller Fault 18 MC18-GB – v1.04 8 Controller Fault 8.1 Fault Code Diagnostic Table Error Code Explanation Actions S.br Temperature sensor fai
Notes MC18-GB – v1.04
2 MC18-GB – v1.04
Copyright © 2014 Carbolite Limited Carbolite, Parsons Lane, Hope, Hope Valley, S33 6RB, England. Telephone: +44 (0)1433 620011 Fax: +44 (0)1433 621
3216 Controller 3 MC18-GB – v1.04 Contents 1 INTRODUCTION TO THE CONTROLLER AND MANUAL 4 1.1 USING THIS MANUAL 4 1.2 PID CONTROL 4 2 BASIC O
Introduction 4 MC18-GB – v1.04 1 Introduction to the Controller and Manual 1.1 Using This Manual This manual aims to explain how to set up and opera
Basic Operation 5 MC18-GB – v1.04 2 Basic Operation 2.1 Controller Layout (Home Display) 2.2 Keys Page Key The Page key is
Quick Start Guide 6 MC18-GB – v1.04 3 Quick Start Guide 3.1 Operation as a simple controller When switched on, the controller goes through a short t
Quick Start Guide 7 MC18-GB – v1.04 When level 2 operations have been completed, the supervisor must return to Level 1 either manually or by ‘power
Programming 8 MC18-GB – v1.04 4 Setting up the controller Before using the controller (or during its lifetime) certain parameters may have to be set,
Programming 9 MC18-GB – v1.04 Press Scroll until the display shows. TEXT <ENABLE/DISABLE SCROLLING TEXT> Use the Up Down to select ON or
Commentaires sur ces manuels